Cement Grout Haze Remover –Cement Grout Haze Remover is an organic acidic treatment designed to remove cementitious grout haze, mineral deposits, rust stains, mortar smears, and efflorescence. Effective for the removal of most hard water stains, lime deposits, and soap scum. Also removes cement grout and mortar residue from tile, concrete, and masonry. Etches concrete. No phosphates.

Contact to buy

Key Features:

• Highly concentrated cost effective
• For heavily soiled and neglected areas
• Removes ground-in dirt, grease, wax and floor finishescos

Environmental Consideration

Complies with all Federal EPA and SCAQMD standards for VOC.

Suitable Tile Types

Natural stone (such as granite, limestone, marble, slate, and travertine), ceramic, porcelain, grout, concrete, quarry, masonry surfaces and other stone and tile.

Health Precautions

CORROSIVE. CAUSES BURNS. HARMFUL IF SWALLOWED. Wear skin and eye protection. Do not breathe vapor or spray. Contains silicic acid. If in eyes, flush with water for at least 15 minutes. If on skin, wash with soap and water. If respiratory tract is irritated, move to fresh air. If irritation persists, seek medical attention. If swallowed, DO NOT induce vomiting. Seek medical attention.

Limitations to the Product:

• Do not allow product to come in contact with any non-recommended surface
• Not recommended for use on vinyl or linoleum surfaces
• Do not mix with other cleaners or strippers

Mixing Procedures

• Mix powder and liquid in plastic container only
• Do not use metal or aluminum containers
• Once mixed, cleaner will remain in solution for several months
• Store unused, mixed solution in a well marked, tightly capped plastic container

Application of Product:

USE CHEMICAL-RESISTANT GLOVES, such as nitrile, when handling product.

Read entire label before using. Sweep, vacuum or wipe surface to remove loose debris. Mix 1 & 2 Deep Clean as follows in a plastic container or bucket:

CLEANING AND STRIPPING: Mix 1/4 cup (30 g) powder to 2 1/2 gallons (9.5 L) of water and mix well. Then add 1/4 cup (59 mL) of liquid and mix thoroughly.
HEAVY-DUTY CLEANING AND STRIPPING: Mix 1/2 cup (60 g) of powder to 2 1/2 gallons (9.5 L) of water and mix well. Then add 1/2 cup (118 mL) of liquid and mix thoroughly.
Note: Mixing solution with hot water is preferable, however, cold water may be used. Liberally apply cleaning solution with mop or sponge. Allow to dwell for 15 to 20 minutes. Agitate with a scrub brush or scrub machine. Do not allow solution to dry on surface. Apply additional solution if necessary. Mop up dirty solution or remove with a wet/dry vacuum. Rinse with clean water.

Cleaning of equipment:

Clean tools with water before material dries.

Storage:

• Close container tightly after each use
• Store in original container only
• Store in and use in temperatures between 45° F to 85° F (7° C to 29° C)
• Store in areas inaccessible to small children
• Do not reuse empty container, wrap and discard in trash or recycle

Product Maintenance:

Properly applied product requires no special maintenance.